Start with what each end connects to
An elbow turns a duct run. An offset shifts its position. A transition changes the opening size or shape; it may also shift the opening. Those functions can occur together, so a name such as “transition” is only the beginning of the description.
Label the equipment side and duct side, or give the openings names such as A and B. Write the width and height at each end and put an airflow arrow on the sketch. That gives every later measurement a clear reference.
Separate opening size from outside size
A flange, hem or connector can extend beyond the duct opening. Liner can also affect the relationship between the metal dimensions and the clear opening. Write down which surface you measured instead of assuming that “24 by 12” tells the whole story.
If the project calls for a lined fitting, identify whether the specified size refers to the sheet metal or the clear air passage. Include the liner requirement with the drawing so the connection can be discussed before the part is made.

Show the offset in a second view
A front view can show opening sizes while hiding a vertical or sideways shift. Add a side or top view whenever the two openings do not line up. Measure from a named edge or centerline and keep that reference consistent.
“Left” and “right” change when someone looks from the opposite end. An arrow labeled “looking from equipment toward duct” is more reliable than a direction written without a viewpoint.
Include the connection ends in the length
Show whether your length is the overall metal length, the distance between connection faces or the clear space between existing parts. A flange or connection allowance can make those measurements different.
Name the required end connection if it is specified. If you are matching existing work, send a close photo of the joint along with the dimensions. A photograph helps identify the detail, but it cannot supply a reliable measurement by itself.
Check the route, not just the finished shape
A fitting may fit its final location and still be difficult to carry through a hatch, raise between framing or join to the next section. Mark nearby beams, walls, pipes and access openings on the layout.
For replacements, show where the existing duct ends and how much room is available to assemble the connection. If a dimension is estimated or hidden, mark it as unverified rather than turning it into a fabrication dimension.
A useful fitting request includes
- A labeled sketch with a clear viewing direction and consistent units.
- The size of every opening, plus the length, angle, radius or offset that defines the shape.
- The end connections and any liner or material requirement.
- Quantity, installation constraints and requested timing.

