First identify what the pan is doing
State whether the pan is collecting drips beneath equipment, serving as a secondary pan or fitting into another assembly. Include the equipment model and the intended location. Those details establish the context for the dimensions and connection requirements.
A fabricated pan is one component of the installation. Equipment instructions and project requirements determine the wider drainage arrangement. Send any specified details rather than assuming that a pan shape by itself establishes how the system should drain.
Distinguish inside space from outside size
The equipment needs usable space inside the pan. The installation needs room for the pan outside it. Folded edges, sidewalls and projecting connections can affect the relationship between those two sizes.
Label length, width and side height separately. State whether your footprint dimensions are inside or outside measurements. If the available opening is the limiting factor, show its maximum clear dimensions as well.
Dimension the drain from named edges
Choose a reference corner and dimension the drain center from two edges. Mark which wall or surface receives the connection and show the direction it faces. “Drain near the corner” leaves both its location and orientation open to interpretation.
Include the connection size and type if specified. A drain fitting can project beyond the pan footprint, so show the piping space and any obstruction near that side.
Show the supports and the route into place
Explain how the equipment and pan will be supported. Mark feet, rails or mounting points that occupy space within or around the pan. The outside dimensions should also be checked against the route into the installation.
An attic hatch, closet doorway or existing piping can limit the size that can be carried into place. A wide photo of the area is helpful; measured clearances establish the actual limit. Do not treat a photograph as a substitute for those dimensions.
Put material and construction requirements on the drawing
Include any specified material, thickness, edge treatment or finish. If the pan needs a slope, a particular seam detail, mounting tabs or a connection at a fixed elevation, state that before fabrication.
Distinguish a requirement from a preference. If you do not know which construction detail is appropriate, explain the application and ask. That is more useful than choosing a material or connection because it resembles a photo.
Before you send the request
A top view locates the drain; a side view explains the height and any slope or projecting connection. With those two views, the team can discuss the pan as a part that needs to fit a real installation.
- Pan purpose, equipment information and installation location.
- Inside or outside length and width, plus side height.
- Drain center location, connection size, type and direction.
- Support details, access limits, quantity and any specified material or finish.

